Hebei Jingxin Chemical Engineering FRP Co., Ltd

FRP Pipe

	Frp Sandy Pipe

Click to enlarge image

Model Number

JX-6

1. Product Characteristics:

Good corrosion proof performance, long useful life.
FRP pipe can resist long time erosion by chemical goods, such as all kinds of acid, alkali, salt, organic solvent, seawater and sewage. Choose different performance FRP according to different medium and temperature.

Good mechanical property
FRP Pipe has light specific gravity(1.8-2.1g/cm3) and high intensity (≥300Mpa), which is higher than steel tube and cast iron pipe.

Good hydraulics performance
FRP pipe has smooth inside surface and small frictional resistance(n≤0.0084), which can reduce pressure loss, increase flow, in the condition of same flow, choose smaller pipe or delivery pump with smaller power, so can reduce the project initial investment and save energy consumption(reduce running cost).

Good design ability, wide accommodation limit.
Change the materials, wrapping angle and speading design to meet the different working pressure, medium, and rigidity requirement so as to product FRP Pipe with different pressure grade and special performance.

Rigidity, Innocuity
Smooth inner surface with no dirt and alga animalcule, has no secondary pollution. The FRP Pipe, which be introduced by food-grade resin, can used for transportation drinking water.

Less tie-in, Good leakproofness
The length of FRP Pipe is about 12 meter, adopt double "O" sealant rubber ring, each tie-in has safe airproof.

Lighter in weight, Easy to transport and install.
The weight is 1/4and 1/10 of the nodular cast iron pipe and cement duct under the condition of with the same specification and length. Easy to transport and install with lower cost.

2. Product Specification:

Diameter: DN300mm-DN4000mm
Pressure grade: 0.25Mpa, 0.6Mpa, 1.0Mpa, 1.6Mpa, 2.0Mpa, 2.5Mpa.
Rigidity grade: 2500N/㎡, 5000N/㎡, 10000N/㎡.
Length: 3m, 6m, 9m And 12m.

Note: We also can produce the product of any pressure grade and length according to the customer demand.

3.Raw materials:

Resin: we can adopt the resin with different cha mortar mortar mortar istics according to different usages.
Continual glass fiber
Quartz sand
Glass fiber felt

4.Formation process:
    We adopt continual glass fiber winding process controlled by computer, which at the International advanced level. We make the inner, inside structural layer, resin mortar layer, outside structural layer, and outside protection layer, heat treatment though Remote infrared ray salamander, and carries on the hydraulic pressure test according to the standard after the solidification.

5.Connection mode:
    Spigot-and-socket joint with double “o” sealing rings, spigot-and-socket joint with single ”o” sealing ring, butt joint, spigot-and -socket joint with gluing, flanged joint, etc.

6.Product inspection standards:
    Both manufactures and inspection are according to standards of AWWA-C950, JC/T838-1998 and CJ/T3079-1998

7.Application: